Rabbit 3000 SBC with LCD and Touchscreen option The XG1000 module includes all the features of existing Z-World RCM modules and adds an impressive list of integrated I/O functions. It is compatible with an RCM3600 and adds buffered outputs, RS232C drivers, SMPS, ADC, DAC, SD-Card, IR receiver, 1-Wire, PC/AT interface and the X-Graph special: an LCD and touchscreen interface. The XG1000 is a compact design with a lot of integrated popular interfaces. All signals are available on standard 0.1" dual-row expansion headers. There is no need for special 2mm headers. Because of the integrated interfaces, backup-battery, power supply and 0.1" headers, your project motherboard will probably only need interface connectors and a socket to plug-in the XG1000 module. No need anymore to design on each motherboard the standard interfaces and power supply you require on all your projects. Just make the motherboard fit the enclosure of your project. The XG1000 is available without an LCD interface. It can be used in many projects were an LCD interface is not required. And, it offers an upgrade path to the other XG1000 family members because the expansion headers on all XG1000 family modules are all identical. You could offer for your project a low-cost version without LCD and a higher priced version with LCD. Three QVGA LCD's are available, a 3.6" B/W (and Blue/White) versions, a 5.7" Blue/White and a 5.7" CSTN Color LCD. All of these are available with a touchscreen. The XG1000 is also available with two different ADC/DAC options. The standard version has an 8-channel 10-bit ADC. But this can be upgraded to a 12- or 16-bit ADC. And a single DAC channel (8-bit or 12-bit) can also be added.   XG1000 Features Rabbit 3000 running at 22.1184MHz (higher speeds available on request) 512kByte program memory (Flash) 128 or 512kByte data memory (SRAM) MMC/SD card socket On-board 3Volt replaceble Lithium battery (SRAM and RTC backup) RS232C line drivers included (Serial Port C and B) or one port with CTS/RTS handshake lines 7 current-sink outputs rated for max. 50Volt and 300mAmp 8 Channel 16/12/10-bit ADC with 5Volt inputs 12/8-bit 5-Volt DAC output Integrated 5Volt switched mode power supply with an input range up to 34V. Other power configurations are possible, including USB power and battery power. 3.3Volt linear low-drop regulator 0.1" female I/O expansion headers (2x34 pins) 0.1" programming header (Serial Port A) 16-key keypad extension connector QVGA LCD interface Analog touchscreen interface 1-Wire interface RC-5 interface PC-AT interface additional RS232C port (RXD/TXD) All on a single module of only 72x94 mm Expansion modules for Ethernet, USB, Modem, RS485, DMX512, WLAN (WiFi), ... A Li battery is standard included for RTC and SRAM backup: